The effect of Al2O3 on the friction performance of automotive brake friction materials


Boz M. , Kurt A.

TRIBOLOGY INTERNATIONAL, cilt.40, ss.1161-1169, 2007 (SCI İndekslerine Giren Dergi) identifier identifier

  • Cilt numarası: 40 Konu: 7
  • Basım Tarihi: 2007
  • Doi Numarası: 10.1016/j.triboint.2006.12.004
  • Dergi Adı: TRIBOLOGY INTERNATIONAL
  • Sayfa Sayıları: ss.1161-1169

Özet

This study consists of two stages. In the first stage, bronze-based break linings were produced and friction-wear properties of them were investigated. In the second stage, 0.5%, 1%, 2% and 4% alumina (Al2O3) powders were added to the bronze-based powders and Al2O3 reinforced bronze-based break linings were produced. Friction-wear properties of the Al2O3 reinforced samples were asto investigated and compared to those of plain bronze-based ones. For this purpose, friction coefficient and wear behaviour of the samples were tested on the grey cast iron disc. The hardness and density of the samples were also determined. Microstructures of the samples before and after the sintering and the worn surfaces of the wear specimens were examined using a scanning electron microscope (SEM). The sample compacted at 350MPa and sintered at 820 degrees C exhibited the optimum friction-wear behaviour, With increase in friction surface temperature, a reduction in the friction coefficient of the samples was observed. The lowest reduction in the friction coefficient with increasing temperature was for the 2% and 4% Al2O3 reinforced samples. The SEM images of the sample indicated that increase in Al2O3 content resulted in adhesive wear. With increase in Al2O3 content, a reduction in mass loss of the samples was also observed. Overall, the samples reinforced with 2% and 4% Al2O3 exhibited the best results. (c) 2006 Elsevier Ltd. All rights reserved.